The second part
of installing Peco turnout motors - the centering devices worked
pefectly and the motor throws the turnout without failure - however the
interface between the turnout motor and layout wiring needs to be
standardised. A 6-hole chocolate block is used to connect the turnout
motor rather than direct connection.
The connections are:
1. Twin-coil earth
2. Left coil
3. Right coil
4. Crossing vee
5. Outer stock rail
6. Inner stock rail

It really is odd, I spend time posting useful tips and ideas about modelling and nothing........not a sausage however I note that idle chatter about adverts or how to tweak the forum seems to attract every one with an agenda. It doesn't matter that these forum discussions are posted in the wrong place, it just seems that we have our priorities totally screwed. No wonder this forum is moribund of modelling activity apart from the faithful few but there sure are a load of people who have an opinion about nothing.
Tim
The connections are:
1. Twin-coil earth
2. Left coil
3. Right coil
4. Crossing vee
5. Outer stock rail
6. Inner stock rail

It really is odd, I spend time posting useful tips and ideas about modelling and nothing........not a sausage however I note that idle chatter about adverts or how to tweak the forum seems to attract every one with an agenda. It doesn't matter that these forum discussions are posted in the wrong place, it just seems that we have our priorities totally screwed. No wonder this forum is moribund of modelling activity apart from the faithful few but there sure are a load of people who have an opinion about nothing.
Tim
