Hi to everybody,
some years ago I bought an Heljan Transfer Table and recently it stopped to work in DCC mode. I can still use it with his control, but I can't move it with my Roco Multimaus or iTrain software, as I did previously.
I'm aware that the settings of the DCC address is quite "odd" :-) but I did the full reset many times as indicated in the manual and tried to assign different addresses but... no way.
At this point I assume that the problem is the decoder, located in the Deck: anyone in the forum got this Transfer Table and may have some suggestion? Any idea if could be possible to change the decoder for himself?
Thanks a lot in advance for any Help!